Ciss Continuous Ink System Fits Canon IX6550, IX6540
*
The Ciss Canon ink system easily fits an ink system to Canon IX6550, IX6540 with the following methods
• First of all one has to start by Removing print head by Pulling the arm 45 degrees.
• Unplug power from machine to bring the cartridge at stable position
• Fit some silicon washel inside the print head carefully using tweezers whose purpose is to provide an air charge seal so that one can get a good print and also to prevent any excess ink coming through.
• Put the print head back in the same position and place the ink cartridges by removing the orange caps one by one.
• After putting the caps of five away, it goes straight into print head
• Now take a green backing tale and a place it over the plastic mould ,byreceding it 1cm. Place 2 more tales separately one on the opposite sides to give it protection.
• Manually push the print head to right hand side so that its free movement is determined and then grab the ink line and create a U-shape to widen the clamp and fit the ink line.
• Stick small clips to the other side and double height clip on the two sides of the printer so that ink line has enoughrim to move.
• Grab sparkplugs and push it inside the sensor and put all of them in the air filters in the system and cover the lid and switch it back and let it run for a test print.
The Ciss Canon ink system easily fits an ink system to Canon IX6550, IX6540 with the following methods
• First of all one has to start by Removing print head by Pulling the arm 45 degrees.
• Unplug power from machine to bring the cartridge at stable position
• Fit some silicon washel inside the print head carefully using tweezers whose purpose is to provide an air charge seal so that one can get a good print and also to prevent any excess ink coming through.
• Put the print head back in the same position and place the ink cartridges by removing the orange caps one by one.
• After putting the caps of five away, it goes straight into print head
• Now take a green backing tale and a place it over the plastic mould ,byreceding it 1cm. Place 2 more tales separately one on the opposite sides to give it protection.
• Manually push the print head to right hand side so that its free movement is determined and then grab the ink line and create a U-shape to widen the clamp and fit the ink line.
• Stick small clips to the other side and double height clip on the two sides of the printer so that ink line has enoughrim to move.
• Grab sparkplugs and push it inside the sensor and put all of them in the air filters in the system and cover the lid and switch it back and let it run for a test print.